Microplastic detection

A portable, Arduino-based microfluidic system for detecting microplastics in water, carried out under the TÜBİTAK 2209-A undergraduate research programme. I work on the sensor electronics and hardware validation.

1. 04.1

   The project was restarted from scratch after the previous team could not make progress.

2. 04.2

   Measurement chain: an MPX2050DP pressure sensor, an LM358P operational amplifier and an Arduino.

3. 04.3

   The current target is a simplified single op-amp differential amplifier, with close attention to the accuracy of component values.

4. 04.4

   Next steps: validate the circuit on a breadboard, measure accuracy and stability, then integrate the sensor electronics with the microfluidic system.

In hardware validation.